Working on a quad bike design with 4 wheel drive, 4 wheel steering and full suspension. Due to its large mostly open center space and direct drive, the Magic Pie motor looks perfect except it would need a new axle and bearing setup. I’d probably remount the controller externally.
In order to proceed, it would be nice to have an installation drawing of the stator, rotor and connecting parts including the shaft and bearings. If these are not available, I’ll buy a motor, take it apart and measure it. Or perhaps someone out there might have a scrap one they’d be willing to sell cheap or donate.
The design will be open source and I’m an old engineer doing it to keep the cobwebs out.
Comments?
