Thank you
@ Philip Yao we have read it carefully now and even before we managed the 2 bikes
bike moves fore half a second and here after the horn beebs continiosly when we turn the throttle
How to Enable/Disable these Functions/Features?
1. Cruise speed control:
Pressing the cruise control button will make your eBike maintain the speed you
are currently at. Squeezing the brakes or pressing the cruise control button again
will disable it.
2. Motor hall-sensor malfunctions:
When the controller detects a motor hall-sensor failure, it will beep twice before
automatically entering into sensor-independent control mode. Twist/press the
throttle to run the motor and pedal your bike for a push start if the motor does not
operate. (This malfunction seldom happens in a state of sensor-independent
control status)
3. Throttle malfunctions:
When the throttle fails to function correctly, the controller will beep three times.
In this situation, press and hold the cruise control button to drive your bike at half
the maximum speed. The controller will automatically return to its original status
when the problem is resolved.
18
4. Power-brake lever malfunction:
If the power-brakes level malfunctions ( i.e. disconnected from the controller),
twist/press the throttle repeatedly for at least four times. The controller will then
beep four times if this malfunction is detected. Similarly, press and hold the cruise
control button to drive your bike at half the maximum speed. The controller will
automatically return to its original status when the problem is resolved.
5. Unknown malfunctions:
If your eBike fails to move and the cause is unknown or if your battery is low, you
can force your eBike to work. While squeezing the power-brakes, press the cruise
control button five times and if you hear the honk from your horn, press and hold
the cruise control button again and you can drive your bike at half speed. You will
need to turn off the battery power to reset the controller back to normal mode after
the problem is resolved.
6. Anti-theft alarm setting:
Cut off power supply to motor (called soft-switch, but controller is still powered
on) and take out the battery key, within 10 seconds press and hold the cruise
control button until you hear a beep sound, then release the cruise control button.
The vehicle is now protected from theft and the motor is electronically locked.
Any movement or vibration of vehicle will trigger the siren for 30 seconds, and
the motorized wheel will resist any pedaling movement.
7. 1+1 Pedal Assist Mode:
Release the throttle to its neutral position during riding, press cruise speed
controller button twice, listen a beep sound, the system enters into pedelec (PAS)
mode. Cut off power supply to the controller to reset this system.
8. Motor phase Calibrating (Use it only if your motor is not from
GoldenMotor):
The controller can work brushless motors with different phase angles other than
defaulted 120 degree. Below are procedures to allow the controller to match the
motor phases:
Cut-off power to controller and motor
Grip and hold power brake lever, turn throttle to maximum speed position,
press and hold the cruise control button, turn on the power switch (using
battery key)
Connect battery power to the system, release throttle, release brake lever,
release cruise control button.
Listen for two beep sounds, then turn the motor wheel forward and reverse
once.
When you hear a beep sound, motor phase calibrating is successful.
If it fails, swap any two of the three motor phase wires, and repeat the above
steps.
