MP2 motor regen. Anyone using it and how long for?

[Leslie]

I had an issue with my old Infineon, so I switched to my spare MP2 with internal controller.  Its been an awesome motor  and have used it quite a bit a year ago, but I have not enabled regen yet.  I was just wondering if any users here are using regen and how reliable is it with the MP2 wheels.

Just interested in sucess to confirm it is doable. 

I feel my MP internal shunt mod may improve the situation lowering the resistance between battery and motor allowing the pack to hammer down any rouge voltage spikes..

[DirtyGinge]

Hi Les


I used regen with the infineons for about 4000 miles with no issue.....but always had it set at about 30% with the goldenmotor controllers...

No issues apart from melted connectors if they werent amp rated ( bullet type)


regards

[Leslie]

Yes the regen on the infineon was good and there was nothing wrong with the contoller until I touched it.  It could be still fine and something maybe a miss with the hall sensor conductors.

If hard wired most of my MP wires with a good solid twist, lots of solder and soldered it with a 60 watt iron, the only connector now is a 50A anderson.  I also added two 10 amp shunts I pulled out of an old GM controller into my MP.  I went for a 20km ride today on my rebuild and it was sweet as.

Thanks for the reply, I got to find my old program cable and try out regen..