« previous next »
Pages: [1]   Go Down

Author Topic: programming the controller  (Read 5199 times)

Offline pengyou

  • New Member
  • *
  • Posts: 5
programming the controller
« on: June 05, 2011, 01:45:27 PM »
Is it possible to program a controller so that it does not begin to send electricity to the motor until the wheel is turning, at say 10 mph?
Logged

Offline DirtyGinge

  • Confirmed
  • PhD. Magic
  • ******
  • Posts: 614
  • Im just trying to find my niche.3 e-bikes is fine
Re: programming the controller
« Reply #1 on: June 05, 2011, 08:57:53 PM »
No, I'm afraid not....the only way is to limit the amps to something like 5, but then after 10MPH, the motor stilll lacks power.....
Logged
Infineon lyen edition 12 Fet
Goldenmotor Magic pie rear ....2000 Watt peak
oh yea.....Im too fat :)...but cute, oh yea, im cute

Offline trike

  • Confirmed
  • New Member
  • *
  • Posts: 23
Re: programming the controller
« Reply #2 on: June 27, 2011, 08:24:17 AM »
If you use the Pedelic Device (PAS), it sort of does that.
Logged
Pages: [1]   Go Up
« previous next »