The other noteworthy observation was the power of the regen brake effect. On the damp roads yesterday I was very much aware the rear wheel could lose traction if the regen 'effect' were used in a sharp corner at speed. Experiencing the vigorous regen effect makes using the actual brakes feel rather dead and lifeless, a bit like stepping on Chairman Mau.
However, I notice the RED light indicating EMPTY on the throttle control shows all the time. It also appears the charger will switch off after 2-3 hours, it gets quite hot. Is this normal?
Bernie,
It's good to hear your bike is working well.
The regen will be more powerful on 24V than it would be on 36 or 48V, but unfortunately there is no adjustment for it.
If they produced these kits with variable regen, it would be much better.
The battery indicator red light should be on all the time, but it should be accompanied by the other two lights when the battery is well charged. As the battery level goes down, the other two light should gradually go out one at a time.
(Assuming you have a 24V throttle unit).
I think these battery gauges were originally intended for lead acid batteries, which have a more noticeable voltage drop as they are discharged, unlike the Lithium battery packs, so don't expect the gauge to be very accurate.
As for the charging time, this will obviously depend upon how discharged the battery is. If you've only used 50% of its capacity, it should charge almost twice as quick as a fully discharged pack.
I don't have a GM battery or charger, so I don't know how hot they get, perhaps someone who does will be able to confirm if this is normal or not.
If it's a universal charger
(110-240V) it may well run hotter and could even charge quicker with the 240V supply you're using.
Has anyone else used the 24V battery pack?
Alan