Getting it to run...

[redbaron]

Hi,

I just received my 48V1000W GM setup. I installed the wheel and rigged all the components up on the bench to test the unit. Batteries are loaded and connected. Breaks, throttle, horn/reverse, motor, hall, all connected. Turn the throttle. Nothing.

Now troubleshooting starts. But where. I have a PAS (pedelec) sensor in my box but I did not connect it. COuld that be it?
Or is there a sequence of initial push/pull/hold, double push or whatever that you need to do to initiate the controller?
Or is it locked because of an alarm?

how to diagnose? I have seen the flowchart and the the most recent FAQ but they are silent to this issue...

Dirk

[TOM]

You could read our schematics drawing,especially 3D,it will help you.

Or you could take a photo with your wire how to connect?

Email to:  zhourenli@goldenmotor.com

Thanks

[e-lmer]

Dirk;

Can you snap a pic of how you hooked up your wires and post them here?

Close up of the speed controller connections will help alot.