Hi all,
Has anyone been able to verify the voltage and amp seetings used during regenerative breaking on the HPC300 or 500 controller?
What I want to know is how stable is the voltage and amp when the motor, in this case a HPM5000B, is being rotated at a current RPM?
I have a setup with a I.C.E, internal combustion engine and a PMAC motor. The PMAC acts as both a motor and a generator. When the I.C.E is running the PMAC acts a a generator and recharges the battery bank.
Since I am using a 48V system with Lifepo4 batteries the voltage generated must not exceed 58.4Volt. The Amp can be up to 90A.
Has anyone tried this? Does anyone have a setup with two HPC controller and two motors to try this?
Best regards
Rikard
