« previous next »
Pages: 1 [2]   Go Down

Author Topic: Conversion of 60deg motor to 120deg motor and vice versa  (Read 9335 times)

Offline MAGICPIE3FOCUSPOWER

  • Confirmed
  • Master of Magic
  • *****
  • Posts: 372
Re: Conversion of 60deg motor to 120deg motor and vice versa
« Reply #15 on: March 10, 2013, 06:29:07 PM »
Aaha well when opened the MP III I see only three slots where I can mount the sensors.

Your motor has more sensors mounting slots?

Yes I think the distance between the sensors matters, because of the timing for the controller.
Maybe can search on internet for more information?
My knowledge is very low at this issue.
« Last Edit: March 10, 2013, 06:30:52 PM by MAGICPIE3FOCUSPOWER »
Logged

Offline Just

  • Confirmed
  • Master of Magic
  • *****
  • Posts: 470
Re: Conversion of 60deg motor to 120deg motor and vice versa
« Reply #16 on: March 10, 2013, 08:33:15 PM »
Quote from: MAGICPIE3FOCUSPOWER on March 10, 2013, 06:29:07 PM
Yes I think the distance between the sensors matters, because of the timing for the controller.
I'm not sure for that since a speed of the wheel/motor vary all the time and the controller should be able to follow these changes... I guess that only sensors config (60 or 120) and the sequence is a matter, not the placement... Again, It's only my guess...
Logged
Pages: 1 [2]   Go Up
« previous next »