Author Topic: Programming the Vector Controller  (Read 38469 times)

Offline Bikemad

  • Global Moderator
  • Professor
  • PhD. Magic
  • ******
  • Posts: 4,752
Re: Programming the Vector Controller
« Reply #60 on: May 21, 2018, 09:59:43 AM »
If the changes you have made are not noticeable, then either they were not "downloaded to the controller" properly or they need to be changed a bit more until you get it working as best as you can.

At least with Bluetooth, you can easily change the settings on the bike and quickly test the effect of the changes.  ;)

If the PAS is still not working at lower pedal cadence, you may be able to add more magnets to the magnet ring on the pedelec sensor (if you can find suitable magnets).

Alan
 

Offline Stegolden

  • Confirmed
  • New Member
  • *
  • Posts: 12
Re: Programming the Vector Controller
« Reply #61 on: May 22, 2018, 02:21:23 PM »
Hi Alan,
yes with bluetooth is too easy.

now i've changed and put these settings:

pas ratio 100
battery drawn current 10
rated phase 35
max forward speed 200
acceleration 50

with level 1 help me only with high cadence frequence
with level 2-3-4-5 the motor help me but with same power

any suggestions?


Offline Bikemad

  • Global Moderator
  • Professor
  • PhD. Magic
  • ******
  • Posts: 4,752
Re: Programming the Vector Controller
« Reply #62 on: May 23, 2018, 09:42:00 PM »
I don't know what else to suggest, if you can't improve it any more by adjusting the settings, then another way to improve the PAS is to purchase a PAS Torque Sensor to enable the motor to provide power relative to the pedal pressure instead of the cadence.

I'm not sure if these will work on their own, or whether a Cycle Analyst is also required.

Here is the user guide for the Torque sensor, but if you need further information, Gary (GM Canada) may be able to answer questions on that particular setup.

Alan
 

Offline Stegolden

  • Confirmed
  • New Member
  • *
  • Posts: 12
Re: Programming the Vector Controller
« Reply #63 on: June 07, 2018, 10:13:14 AM »
Hi,
now i've solved the problems on cadence.

with different sensor and magnets i've a quickly response from motor.

just the problem on the levels remain.......with level 1 or level 5 I get ever same assistance!