One wheel drive. What happened?
Oh how did I not see the rest of that post? I think you edited it while I was reading it haha just saw all of this now
You've probably already read the post about how the wheel died. Anyway I contacted Tom and he sent me a replacement controller which went in with some careful 'safety' mods like heatshrink around the phase wires then epoxy over the ground track on the bottom of the board so the phase wires can never short.
I must say the quality of the phase wires were much better (heat resistant casing) then the older pies.
And to my amazement after I replaced the controller it's now so much better than ever! Haha so it was fate me thinks.
Hey Gary do you run 2 batteries with your setup or just 1? I run 1 and pre-replacement it was okay but now I'm leaning to either an additional battery, or building one into my frame that can handle the Monkey power...
And cheers for answering all my questions I didn't know I had so many!
MM<