Using single throttle and brake on two motors

[Yeekevin11]

I am attempting to wire a single throttle and a single brake to two Magic Pie 4's. Is there a schematic and/or pin-out diagram of the throttle and brake cables that I can use in order to create the parallel lines?

Any advice is appreciated. Thanks.

[Yeekevin11]

I was able to find this for the MP3. I would like something similar to MP4. Thanks

http://www.goldenmotor.ca/FAQ/questions.php?questionid=99

[Bikemad]

I think this is what you are looking for:



You can link the Throttle Signal, Cruise Signal, Brake Signal, Battery+ and Battery- (Ground) but do not connect the two +5V wires together as this has been found to cause problems.

Alan
 

[Yeekevin11]

Thanks, Alan. This looks great. Do you happen to know which color wire correspond to which pin? Thanks

[Bikemad]

I have no idea what the colour of the wires inside the harnesses are so you would have to do a continuity check using a sharp pin in each of the wires to identify which wire goes to which pin.

There might be some further information here but I don't know if it contains what you are looking for.

Alan