GoldenMotor.com Forum

General Category => General Discussions => Topic started by: redbaron on April 17, 2009, 05:12:11 PM

Title: Getting it to run...
Post by: redbaron on April 17, 2009, 05:12:11 PM

Hi,

I just received my 48V1000W GM setup. I installed the wheel and rigged all the components up on the bench to test the unit. Batteries are loaded and connected. Breaks, throttle, horn/reverse, motor, hall, all connected. Turn the throttle. Nothing.

Now troubleshooting starts. But where. I have a PAS (pedelec) sensor in my box but I did not connect it. COuld that be it?
Or is there a sequence of initial push/pull/hold, double push or whatever that you need to do to initiate the controller?
Or is it locked because of an alarm?

how to diagnose? I have seen the flowchart and the the most recent FAQ but they are silent to this issue...

Dirk

Title: Re: Getting it to run...
Post by: TOM on April 18, 2009, 12:20:01 AM

You could read our schematics drawing,especially 3D,it will help you.

Or you could take a photo with your wire how to connect?

Email to:  zhourenli@goldenmotor.com

Thanks

Title: Re: Getting it to run...
Post by: e-lmer on April 27, 2009, 12:31:47 AM

Dirk;

Can you snap a pic of how you hooked up your wires and post them here?

Close up of the speed controller connections will help alot.