GoldenMotor.com Forum

General Category => Magic Pie & Smart Pie Discussions => Topic started by: MrFred on September 07, 2018, 08:22:22 PM

Title: Programming MP Edge with USB Cable and GM program
Post by: MrFred on September 07, 2018, 08:22:22 PM

Is there anywhere or any document where ALL of the parameters that can be set using the USB Cable and GM program are described?

I have seen the GM video that describes some of them, but was looking for something more complete.

Title: Re: Programming MP Edge with USB Cable and GM program
Post by: Tommycat on September 07, 2018, 09:34:10 PM

(https://i.imgur.com/Uq3w0HI.jpg)

The MP5 is limited to 12. Like everything else in this field it seems you have to gleen the forums...   :P

I think they are pretty much self explanatory, albeit odd nomenclatures sometimes. But I'll vote you in for a sticky if you write em out. BTW nice work on the PAS info.  :)

Regards,
T.C.