GoldenMotor.com Forum

General Category => Magic Pie & Smart Pie Discussions => Topic started by: Adamsavage79 on March 31, 2018, 05:46:56 PM

Title: Wiring Harness Mess
Post by: Adamsavage79 on March 31, 2018, 05:46:56 PM

I got the motor on the frame, with only minor grinding to the drop outs. I just have to install the Torque arm, and the LCD Display. However, I noticed I have quite the mess with the wiring now. It's much too long for my frame and I'm not sure what to do with the extra slack. Suggestions ?

Title: Re: Wiring Harness Mess
Post by: Andrew on March 31, 2018, 08:50:53 PM

If tou don't wnat to snip any cables and repalce connectors, you could buy a small corner frame bag and stuff the excess into it.  And get yourself a bag of cable ties and run all wiring along the frame neatly

Title: Re: Wiring Harness Mess
Post by: Adamsavage79 on March 31, 2018, 11:01:04 PM

I have cable ties. There is no other way to have them snug against the frame. I ended up just puttin the exess into a loop and rested it on the frame.

Title: Re: Wiring Harness Mess
Post by: Hastings on April 01, 2018, 12:57:11 PM

A few years back I had the same problem . I used selfvulcanizing tape to fix the excess cabling to the frame -still works

Title: Re: Wiring Harness Mess
Post by: Tommycat on April 01, 2018, 01:29:59 PM

 
Stuffed excess wiring, connectors, and amp shunt in a front panel box and make-up box in the back. When things get sorted may try to get things in my rather wide downtube...


(https://i.imgur.com/mVotTB6.jpg)



(https://i.imgur.com/QefOEHj.jpg)



(https://i.imgur.com/xrkzLgd.jpg)


Regards,

T.C.