GoldenMotor.com Forum
General Category => Magic Pie & Smart Pie Discussions => Topic started by: Magiva on October 22, 2016, 03:38:39 PM
-
I'm trying to hook up a PAS to a Smart Pie 4 with 48V. I'm also using a BAC-601.
I have enabled PAS mode by clicking up a few times on the BAC, yet there is nothing happening when I am spinning the pedals.
The trike is in the workshop with free spinning wheel.
PAS ratio set to 75
Acceleration 100 (i did test 40 aswell)
Measuring the yellow PAS-signal wire it toggles between 0 and 2.97 Volt as I slowly spin the pedals. Is this correct?