GoldenMotor.com Forum

General Category => Magic Pie & Smart Pie Discussions => Topic started by: Yeekevin11 on July 28, 2015, 01:17:28 PM

Title: Using single throttle and brake on two motors
Post by: Yeekevin11 on July 28, 2015, 01:17:28 PM

I am attempting to wire a single throttle and a single brake to two Magic Pie 4's. Is there a schematic and/or pin-out diagram of the throttle and brake cables that I can use in order to create the parallel lines?

Any advice is appreciated. Thanks.

Title: Re: Using single throttle and brake on two motors
Post by: Yeekevin11 on July 28, 2015, 01:27:57 PM

I was able to find this for the MP3. I would like something similar to MP4. Thanks

http://www.goldenmotor.ca/FAQ/questions.php?questionid=99

Title: Re: Using single throttle and brake on two motors
Post by: Bikemad on July 28, 2015, 05:02:11 PM

I think this is what you are looking for:

(http://www.arhservices.co.uk/GoldenMotor/MP4/MP4%20and%20SP4%20Harness%20details_zpskxkfbgbw.JPG)

You can link the Throttle Signal, Cruise Signal, Brake Signal, Battery+ and Battery- (Ground) but do not connect the two +5V wires together as this has been found to cause problems.

Alan
 

Title: Re: Using single throttle and brake on two motors
Post by: Yeekevin11 on July 30, 2015, 06:00:10 PM

Thanks, Alan. This looks great. Do you happen to know which color wire correspond to which pin? Thanks

Title: Re: Using single throttle and brake on two motors
Post by: Bikemad on July 30, 2015, 08:35:52 PM

I have no idea what the colour of the wires inside the harnesses are so you would have to do a continuity check using a sharp pin in each of the wires to identify which wire goes to which pin.

There might be some further information here (http://goldenmotor.com/SMF/index.php?topic=5585.msg31759#msg31759) but I don't know if it contains what you are looking for.

Alan