GoldenMotor.com Forum

General Category => General Discussions => Topic started by: trike on December 02, 2014, 08:27:15 PM

Title: BAC-0281P external controller.
Post by: trike on December 02, 2014, 08:27:15 PM

Should I run my BAC-0281P External Controller out in the open somewhere or can I run it in a bag.

Title: Re: BAC-0281P external controller.
Post by: Bikemad on December 05, 2014, 11:54:28 AM

Keeping the controller cool is very important, especially if you are using high current settings and lots of throttle.

Ideally, the controller should be mounted where the airflow can easily pass over the cooling fins to provide optimal cooling.
It should be possible to fit the controller inside a box or bag to allow the wiring and connectors to remain clean and dry, but leave the cooling fins exposed like Phil did:

(https://i.imgur.com/CSIPwdE.png) (http://goldenmotor.com/SMF/index.php?topic=3212.msg19307;topicseen#msg19307)

Take a look at this post (https://goldenmotor.com/SMF/index.php?topic=4369.msg25433#msg25433) for a similar suggestions.

Alan
 

Title: Re: BAC-0281P external controller.
Post by: Hastings on December 06, 2014, 05:23:17 PM

 Hi   Have a look at my solution: ie an external cooler for a built in controller best of two worlds

http://goldenmotor.com/SMF/index.php?topic=5010.msg29172#msg29072 (http://goldenmotor.com/SMF/index.php?topic=5010.msg29172#msg29072)