GoldenMotor.com Forum

General Category => Magic Pie & Smart Pie Discussions => Topic started by: Supchrgamx on May 10, 2014, 03:05:27 AM

Title: MP3 CONTROLLER
Post by: Supchrgamx on May 10, 2014, 03:05:27 AM

Im running 48v 15 ah and the bms has a 30 amp shut off
the software control seems to not work ,when I turn it to 20amp peak and run, it stills pulls to 30 amps
is this normal
Laurence

Title: Re: MP III CONTROLLER
Post by: Supchrgamx on May 10, 2014, 04:22:18 AM

windows 7 64 bit

connect successful
get config doesn't work
disc doesn't work

Title: Re: MP III CONTROLLER
Post by: Supchrgamx on May 11, 2014, 10:31:24 PM

seems like the driver software for the usb cable is for 32 bit machines
any 64 bit drivers on the horizon?
otherwise the bike is awesome

Laurence

Title: Re: MP III CONTROLLER
Post by: Supchrgamx on May 14, 2014, 05:31:40 AM

ok I don't know what im talking about,just tried vista 32 bit. same thing, I give up, liening towards some thing died. maybe im being to rough on it. after all ,I did get a trip to the hospital for a cat scan because I was having way to much fun and then walked funny, for six months.

Title: Re: MP III CONTROLLER
Post by: Supchrgamx on May 17, 2014, 02:12:35 AM

I guess when it says its connected, that means that it is only connected to the ic in the usb cable and not nessasarly connected to the controller. on further inspection I found some chaffed wires going to the future display jack. after moving them around abit ,access was granted to the controller.so far I like what I see and on a side note the usb feeds the controller with 5 volts and it is switched on and off by the ic in the usb cable, so it(5v) appeared after successful connection