GoldenMotor.com Forum

General Category => Magic Pie & Smart Pie Discussions => Topic started by: Kris on April 22, 2013, 11:16:29 PM

Title: Smart Pie Phase angle?
Post by: Kris on April 22, 2013, 11:16:29 PM

I want to remove the internal controller from a smartpie so I can run the motor from a Kelly controller in order to have a play with variable regen. The Kelly controller config software is asking if the hall sensors are 60 or 120 degree. Does anybody know?

Title: Re: Smart Pie Phase angle?
Post by: Bikemad on April 23, 2013, 12:03:33 AM

As far as I'm aware, all the GM hubmotors use the 120 degree setting in the GM software, I seem to recall that setting it to 60 degrees would force the older GM controllers to run only in sensorless mode (Pedal first).

Alan
 

Title: Re: Smart Pie Phase angle?
Post by: Kris on April 24, 2013, 08:26:02 AM

thank Al