GoldenMotor.com Forum
General Category => Magic Pie & Smart Pie Discussions => Topic started by: Hastings on April 23, 2012, 03:49:22 PM
-
Hi everybody
After a year of delay as I ordered the wrong size: 28 inch/635 mm MP2 when a 700c/622 was needed, Finally:
I got my bike up and running with a Ping 48v16 AH Battery. So far I have made a stainless battery box but not included an on -off switch as I need one the can handle the amps if I should place it between battery +and the controller
My question is if the thin red cable that is not handling the load( see the very top off the diagram) can be used for on-off signaling trough the software? and if so do I have to activate it from a change in settings in the sofware? Right now the bicycle can be driven without this cable . It is labled off -on ....
Does any off you use a fuse and how strong ? 60 A ???