GoldenMotor.com Forum
General Category => Magic Pie & Smart Pie Discussions => Topic started by: Andrew on December 27, 2011, 04:47:19 PM
-
I pull the throttle and have power for 2 seconds. Then power cuts out and will only power again if I release throttle and re-apply and the same thing happens again. I've resoldered throttle wires, all hall wires seem ok. Could it be a phase wire problem? :(
Andrew
-
Sounds more like low Voltage cut out. Does it do it with no load?
-
i've only tried it without load. LVC is set to 42v on a 54v pack. My Cycle Analyst is showing the battey at over 53v at present.
It maybe that I have some how mixed up the phase wires I will have to try lots of combos
Any other suggestions would be much appreciated
-
Looks like you have to eliminate possibilities. Try a different battery, throttle, controller, etc. Maybe swapping one item out will reveal something. I know you have an assortment of stuff. Try replacing things if possible. Im really not sure what could be doing it but thats what I would try.
Gary
-
Thanks Gary. I will try some differing phase wire combos first, but I do have spare throttle and controller if necessary :)
-
tried all 36 wire combinations and could only get a two third rotation of the wheel under throttle until cutout.
Taken pie apart today checked all hall wires which are all good. Looks like a hall sensor failure on the motor >:(