GoldenMotor.com Forum

General Category => General Discussions => Topic started by: shacketj on November 10, 2008, 10:58:06 PM

Title: rad2go Q chariot....General question...Pleeeeeeeease help....
Post by: shacketj on November 10, 2008, 10:58:06 PM

PLEEEEEASE help...

I picked up a scooter from my neighbor and thought it would be a quick fix to get it up and running.

36V, two 180W hub motors with new batteries and brakes. 

When I replaced the batteries and connected it all together, the wheels just started spinning even with the key in the "off" position.  I checked all the connections and everything seemed right.  I talked to a shop and was told that I needed to replace the motor controller.

After hours searching, I found the speed/volt controller (LBD14 or YK40), but still need to find the "brain" that connects to the two motors.  I can find a million parts that connect to a single motor, but nothing with two connectors...

Help...

Title: Re: rad2go Q chariot....General question...Pleeeeeeeease help....
Post by: fbvisitor on November 13, 2008, 11:55:09 PM

How about a few pictures.

I'm sure one the many helpful people who drop by this forum will have a better idea of what the problem is when they see it.

Cheers.

Title: Re: rad2go Q chariot....General question...Pleeeeeeeease help....
Post by: TOM on November 17, 2008, 08:47:22 AM

from 180w,I think  your motor controller must 24V,
when you put through 36V voltage,
24V motor controller must be broken

I have met before.