GoldenMotor.com Forum

General Category => General Discussions => Topic started by: pengyou on June 05, 2011, 01:45:27 PM

Title: programming the controller
Post by: pengyou on June 05, 2011, 01:45:27 PM

Is it possible to program a controller so that it does not begin to send electricity to the motor until the wheel is turning, at say 10 mph?

Title: Re: programming the controller
Post by: DirtyGinge on June 05, 2011, 08:57:53 PM

No, I'm afraid not....the only way is to limit the amps to something like 5, but then after 10MPH, the motor stilll lacks power.....

Title: Re: programming the controller
Post by: trike on June 27, 2011, 08:24:17 AM

If you use the Pedelic Device (PAS), it sort of does that.