GoldenMotor.com Forum

General Category => General Discussions => Topic started by: Andrew on April 21, 2011, 11:33:16 AM

Title: one GM brake lever to two external controllers for motor cut-off
Post by: Andrew on April 21, 2011, 11:33:16 AM

 How easy is it to wire GM brakes to both controllers in order that both motors cut out when only one brake lever is pulled. I'm sure it's easy but I don't(as yet) have the parts in front of me to work it out!
  Is there a diagram? :)

Title: Re: one GM brake lever to two external controllers for motor cut-off
Post by: DirtyGinge on April 21, 2011, 04:34:11 PM

I just wired the wiring from the brakes, and connected with both sets of brake wires from the controller, worked fine :D

Title: Re: one GM brake lever to two external controllers for motor cut-off
Post by: krelle52 on April 21, 2011, 04:41:44 PM

Hi andrew

First I thought it was easy, but now I'm slightly in doubt about the need for the brake to be connected to z terminal on both controller. I made a quick diagram. This is my suggestion and I'm pretty sure it's right. But I would like a second opinion!

/ Krelle52

Title: Re: one GM brake lever to two external controllers for motor cut-off
Post by: krelle52 on April 21, 2011, 04:59:57 PM

There was someone faster than me. :)

Title: Re: one GM brake lever to two external controllers for motor cut-off
Post by: Andrew on April 21, 2011, 05:05:53 PM

Quote from: krelle52 on April 21, 2011, 04:59:57 PM

There was someone faster than me. :)

ha ha :D.   thanks both. once I have the bits in front of me I know it will be straight forward