GoldenMotor.com Forum

General Category => General Discussions => Topic started by: bernix on April 13, 2008, 09:56:46 PM

Title: Probleme reglage of 12 phases
Post by: bernix on April 13, 2008, 09:56:46 PM

Hello,
I do not manage to settle(adjust) my engine to one of 12 phases.
One of the phases works correctly with the jumper.
The engine turns normally and noiselessly.
But when I remove the jumper, the engine does not start any more.
If somebody already has to observe this probleme and knows how to resolve it.
Sorry for my English, I am French
goodbye

Title: Re: 12 Phases detection motor problem
Post by: Velocyraptor on October 29, 2009, 01:10:00 PM

Hi
I can't setup the motor detection
I think I have over limit the 12 phases detection and my motor not still work (noisy, chokes ans spins). And when I setup it's the same thinks (noisy chokes spins, no movements).
So how I do to reset 12 phase detection limit ?
Must I desactivate regen breaking function when I setup motor phase ?

I think I have not understand all the english instructions I do "sh!t" :s

Thanks you

Title: Re: Probleme reglage of 12 phases
Post by: Electrobent on October 29, 2009, 08:31:52 PM

The instructions posted are not correct for the regen but not "magic" controller.

Put the jumper in place.
Turn on system
goose throttle for 1 sec bursts until you get to the best forward rotation.
Remove Jumper
goose throttle one more time
cycle power.