GoldenMotor.com Forum

General Category => General Discussions => Topic started by: perdigon on April 02, 2010, 01:37:45 PM

Title: open minimotor 250w
Post by: perdigon on April 02, 2010, 01:37:45 PM

anyone knows how to open a mini-engine 250w

Title: Re: open minimotor 250w
Post by: Bikemad on April 02, 2010, 02:47:38 PM

The photos in this post (http://goldenmotor.com/SMF/index.php?topic=1576.msg7918#msg7918) might help.

Alan

Title: Re: open minimotor 250w
Post by: perdigon on April 02, 2010, 03:41:01 PM

the engine is back

Title: Re: open minimotor 250w
Post by: perdigon on April 02, 2010, 11:29:29 PM

I see no way to open the engine

Title: Re: Opening the 250W minimotor
Post by: Bikemad on April 03, 2010, 12:44:48 AM

Your minimotor is different to the others that I have seen, but I would say the left hand cover must be unscrewed
(http://goldenmotor.com/SMF/index.php?action=dlattach;topic=2009.0;attach=1842;image)
using a tool like the one shown below:
(http://www.goldenmotor.com/accessories/images/buy_tool2.jpg)
                                       ^
                                         ¦
                                   This one

It's the only way that I can see to open it.

Alan
 

Title: Re: open minimotor 250w
Post by: perdigon on April 03, 2010, 01:17:02 AM

ok thx alan

Title: Re: open minimotor 250w
Post by: Leslie on April 05, 2010, 03:54:08 AM

You could use a mallot and a centre punch to unscrew the cover but that may be a bad thing and cause damage.  You could cut the tool drill three holes and use high tensile screws to make the three pins. Or find some junk and get a steel disk with no centre, drill three holes and secure three pin screws that extend out from the other side and use a lever or large screw driver in between the screws and turn..