91
User Guides/Catalog / Re: light and horn
« Last post by Bikemad on January 11, 2024, 09:13:16 PM »Mark, the holes in the frame bracket are not threaded, they are just clearance holes for the M6 bolts that pass through them and then thread into the caliper mounting piece:
Please note that you only need to fabricate the section shown in blue (not the entire bracket) and it may have to be shaped differently to fit your particular frame:
Here's an example of a different bracket shape:
The most important thing to get right is the distance between the two 6mm mounting holes and the distance of each of these holes relative to the centre of your axle.
Please note that the centre of your 14mm diameter axle is likely to be at least 2mm lower than the one shown in the dropout above for a standard 10mm axle (unless you have already filed 2mm into the dropouts)
Alan.
Please note that you only need to fabricate the section shown in blue (not the entire bracket) and it may have to be shaped differently to fit your particular frame:
Here's an example of a different bracket shape:
The most important thing to get right is the distance between the two 6mm mounting holes and the distance of each of these holes relative to the centre of your axle.
Please note that the centre of your 14mm diameter axle is likely to be at least 2mm lower than the one shown in the dropout above for a standard 10mm axle (unless you have already filed 2mm into the dropouts)
Alan.