GoldenMotor.com Forum
General Category => General Discussions => Topic started by: scott on October 10, 2009, 09:32:45 PM
-
Wheel was spinning nicely until the free wheel (6 speed gear tightened up).Binding soon ensued. I think it need the shim(washer?). Where does it go?
Tkanks
Scott
P.S I set two U clamps on both sides of the rear frame and ran a cable tightener between them .Turning the cable tightener backwards .Work like a charm for spreading the rear axel gap on the frame.
Cost me 3.75 CDN. Save me “finger knuckle abuse”.
I will send a picture ,,,,,when I find out how.
-
I think it need the shim(washer?). Where does it go?
Scott,
The shim needs to be fitted between the freewheel and the hub.
(http://www.arhservices.co.uk/GoldenMotor/Shim.JPG)
If you want to include an image with your post, then use the 'additional options' and browse
to the image on your computer.
Alan
-
Thanks.