General Category > User Guides/Catalog

I need help with external controller wiring to Magic Pie motor.

(1/2) > >>

moopro:
My internal controller is not working so I boght the external one ,Where should I Connect the motor ? (how)
should I opten the motor covers and solder new cables? or just use the old cable coming out from the motor?

How can I confirm if the motor is working or not? is there any place I can test it?

e-lmer:
Please only post your question once in the correct
forum.

This question is not a user guide/catalog question.

You must open the Magic Pie by removing the side cover.

Once open, you must disconnect the internal controller from
the three motor main leads and the 5 hall sensor leads.

Extension cord wire will work for the motor main leads, and
telephone wire will work for the 5 hall sensor leads.

You will take these eight wires and run them out through
the Magic Pie axle (after filing the edges of the slot
in the case to make them smooth.)

moopro:
Sorry for wrong posting.
I removed the old controller but I was not able to remove the bearing wheel to remove the old cable! (its hard to remove the cable without removing the bearing wheel !, is it possible to remove it?

MonkeyMagic:
Moopro

You need to remove the circlips. You can do this without Circlip pliers but you will most likely damage the clip rendering it useless.

If I were you, I would buy some circlip pliers and safely remove the clips.

When I was frustrated, I filed down a set of long nose pliers into somewhat circlip pliers that worked well for all of 2 minutes lol

Go down to your local auto/hardware store and buy a set of circlip pliers, and if they have a bulk multipack of circlips buy them too. Get some spares you will need them.

You can assemble your wheel back without circlips but you will most likely have problems in future, so do it right the first time :)

moopro:
Thank you for replies!  now I have connected everything and connected the battery for a test ,the motor is finally running , I was very happy for that . now the problem is the motor is going in reverse as default. is there anything wrong with my cables?

Navigation

[0] Message Index

[#] Next page