GoldenMotor.com Forum
General Category => Magic Pie & Smart Pie Discussions => Topic started by: Standartuser on July 06, 2017, 08:38:21 AM
-
Hi Everybody,
I have a little Problem with my PAS on my Edge. It is working so far, but not right.
When I start pedaling, the Motor gives Power and suddenly it stops, then comes Power again, it stutter at start up.
That happens with Mobile Phone with APP in PAS Step 5 , also without Phone. If I reduce the Power in the Settings/ reduce the drain, it is a different Result, but still stutter...
Anybody here, with same Problems?
-
So, after a while I solved the problem.
I bought a Voltage controlled PAS from china, and its working pretty good.
Also I had a Problem with the Maximum Speed here in Germany...we are allowed max 25Kph with Pedelec Mode. NO throttle allowed.
I build a little electronic switch for this.
There are following things included...
1. COP MODE 8) After Power on, the Bike is driving max 25kph with Pas ..
2. unlocked Mode There is a hidden pushbutton switch, after pushing it, the COP MODE is off, the Motor gives full power at PAS Mode.
3. Full Power Button A second hidden mikrobutton, that gives full throttle, when pushing it. useful at traffic lights, for kickdown ;)
4. I use a backback for my battery, if I dismount of the bike I disconnect the power, after Power on the system, the cop mode is activated.
-
Have you wired the voltage controlled PAS to the existing PAS connector, or does it go directly to the throttle connector in place of the throttle unit?
Do you have a circuit diagram showing all connections (and details of the components used) for this electronic switch?
It's difficult to figure out how it actually works just by looking at the photo. :-\
Alan
-
Hi Alan, the Pas vMode is connected to the throttle Unit.
You should have the Schematic in your Email Box.
Daniel ;)