GoldenMotor.com Forum
General Category => General Discussions => Topic started by: PaintingLoft.com on August 30, 2008, 06:29:32 AM
-
I just got and charged my Foxx Power battery and now I realize that it doesn't plug into the wire I need it to plug into. what is everyone else doing? can someone put a pic up? that would be the best as a lot of this electric lingo is a little over my head.
thanks in advance for any help. this is a little frustrating. :(
-
(http://farm4.static.flickr.com/3136/2810477577_379222714f_t.jpg)
ok. so the question is: how do I get this attached to the stripped red and black battery hanging off my battery? that is what I am suppose to do right? why wouldn't they just have those two wires end in a plug like this? am I suppose to cut this off and solder the controler to the battery? if so then the next time I charget the battery the controler will still be attached. I assume that is not good. isit?
arg!!!
-
ok.. so I got this far plugged it in and NOTHING! the battery meter is lit up but the throttle is doing nothing. am I wired up wrong? at this point I have no more ideas.
(http://farm4.static.flickr.com/3104/2810920015_43d4b1c561.jpg)
(http://farm4.static.flickr.com/3119/2810920953_be43e3f355.jpg)
red to red, black to green and yellow? is that right?
(http://farm4.static.flickr.com/3075/2811765894_801b97a53d.jpg)
(http://farm4.static.flickr.com/3081/2810921819_3d33b8a035.jpg)
-
I bought the regen and the standard controller was shipped with the kit so I cut it off of the standard controller plug and soldered/heat shrank it on. Everybody and their mother uses different plugs for everything in the world. If I had not had the other matching plug I would likely have installed Anderson connectors as they are everywhere and of good quality.