General Category > Electric Motorcycle Conversion

3kw bldc motorcycle conversion issues/questions

<< < (6/6)

Tommycat:
I doubt that they would change the pin-out.   :o

Following the wiring diagram above. Last ditch effort would be to disconnect the 30 pin connector and everything else except for the battery B-  and B+ wiring. Checking for full battery power from (B-) ground to BOTH B+ terminals. And then CAREFULLY run a jumper wire from B+ directly to pin #10 (e-lock), lower right corner. Being careful not to touch any other pins or shorting. If the LED doesn't light up then, I'm stuck... :-[

I don't know if a controller programmable setting could cause his issue? Have you tried resetting to original configuration?
 

Motolittle:
Tommycat I'm thankful for your continual help!

I have checked the fuse for continuity and checked that I'm getting voltage to both terminals...

Than I have backprobed to check that voyage is getting to the e lock pin.... still nothing... no red lights.....

I have contacted my supplier to see if he can help troubleshoot this a bit more too!

If anyone thinks of anything else let me know. Thank you all!

Navigation

[0] Message Index

[*] Previous page