GoldenMotor.com Forum
General Category => Magic Pie & Smart Pie Discussions => Topic started by: Hastings on May 10, 2020, 08:28:48 AM
-
Hi
I am restarting a project where I as yet only got the bicycle (q 29 er with good front suspension and hardtail), Thun torque sensor and a Cycle analyst v3 .
I am looking to buy an Edge and a a 10Ah lifepo battery that I will mount on the frame lika a shark battery but bigger.
It has hydraulic brakes (Shimano) and I constructed a Hallsensor/magnet assembly a year ago .
I have been looking at Higoconnectors https://www.higoconnector.com/products/collection/motor/w999K
Are they compatible with the Edge´s harness or not?
They are on offer from this site https://www.e-bike-technologies.de/index.php/en/connectors/connectors-signal/connectors-higo-and-julet-z8-series/higo-z812-s-detail
-
I don't think the 10 pin Higo connectors will be compatible with the Edge main harness connector as the 10 pin connector used on the Edge has a different pin layout:
(http://www.arhservices.co.uk/GoldenMotor/MP4/MP4%20and%20SP4%20Harness%20details_zpskxkfbgbw.JPG)
(https://i.imgur.com/2kWo2WG.png) (https://www.higoconnector.com/products/collection/main-cable/t999K#title)
The 8 pin Higo connector appears to be the same pin layout as the original MPIII's before they were changed to the MP4/5 10 pin connector:
(http://www.arhservices.co.uk/GoldenMotor/LatestMP3wiring.JPG)
However, the Higo 3, 4, and 5 pin Mini B connectors do seem to be very similar to the smaller Edge connectors: ;)
(https://i.imgur.com/fNs1KxT.png) (https://www.e-bike-technologies.de/index.php/en/connectors/connectors-signal/connectors-higo-mini-b-series/higo-mini-b-with-overmolded-cable)
Alan