GoldenMotor.com Forum

General Category => Electric/Hybrid Car Conversion => Topic started by: murphylee on August 19, 2012, 04:05:29 PM

Title: Monintoring program keeps showing the same error message!
Post by: murphylee on August 19, 2012, 04:05:29 PM

Hi, Guys!

My name is Yong and building a electric car with my team in Korea.

A couple of weeks ago, I purchased 10kw 48v BLDC motor via Ebay and a 48v 300A controller from Korean dealer.

The first problem I found was that the hall sensor connector from motor is 5pin but hall sensor connector from the controller was 6pin.

So I cut them off and just connected only wires.

and I also connected foot pedal to the controller with no connector as well.

but the program keeps showing the same message.

Current shutdown of DC contractor1 (pin3)

I am fully aware of that pin2 and pin3 are disconnected! cus I didn't connect them to anything

furthermore I used wiring diagram with no contactor.

Is contactor necessary for the controller that I'm using?

I also tried with DC Power supply but It's not in the photos.

Pls someone help me!

and the Korean dealers keep repeating all they can do is e-mailing to you ! GM!

Title: Re: Monintoring program keeps showing the same error message!
Post by: Morgen 3Eman on August 19, 2012, 05:54:43 PM

Hi Yong,

This group can be pretty helpful, but you need to supply more information.  The specifics are very important; exact brand name and model numbers of all the components you are using, wiring diagrams you may  have received, etc.  You just haven't provided any of that. 

I really like the  socks in the last photo, tho.

TTFN,
Dennis

Title: Re: Monintoring program keeps showing the same error message!
Post by: Bikemad on August 20, 2012, 02:06:10 AM

Take a look at this post (http://goldenmotor.com/SMF/index.php?topic=4489.msg25937#msg25937) for more information on the HPC300 controller.

Alan
 

Title: Re: Monintoring program keeps showing the same error message!
Post by: murphylee on August 20, 2012, 07:31:31 AM

Let me add more photos.

These are the labels on the motor and the controller.

and definitely they were all from GM

Title: Re: Monintoring program keeps showing the same error message!
Post by: SGRAND on December 17, 2012, 04:06:36 PM

Hello,
Did you find the solution, that she person could help you?
I also have a problem

72V battery voltage
SPEED NO LOAD 4300T/MN??????
INSTEAD OF 6000T/MN
WITH A VOLTAGE ACROSS THE ENGINE 54V?????
PROBLEM SETTING??

program HAVE YOU
THE DETAILED MANUAL
CONTROLLER?:

SPEED-  I(%)              ?
SPEED-P(%)               ?
CURRENT-I  (%)           ?
CURRENT-P(%)           ?
FWD DEGREE            ?
REV  DEGREE            ?
PAGE REVISE            ?

If you have examples of diagrams, and other thank you

cordially

M grand